3 RANGE ATTENUATOR.
2 POWER SOURCE.
1000V INPUT CAT III
LOW BATT. AUTO OFF.
SEPARATING DESIGN.CONVENIENT, DURABLE.
MEET CE, IEC 1010, EN 61010, UL 3111.

Band width (-3dB, 50Ω load): DC-25MHz . ( x 20: DC~15MHz)
Accuracy : ± 2% at 20-30℃ 70% RH after 20 minutes warm up.
Attenuation : x 20, x 50, x 200 ( Into 1MΩ scope ) ; x 40, x 10
, x 400 ( Into 50Ω load )
Maximum operation Voltage ( DC + peak AC ) :
≦ ± 140V at x 20
≦ ± 350V at x 50
≦ ± 1300V at x 200
Maximum input Differential Voltage : 1300V ( DC + peak AC ) or 1000V RMS
Maximum input Voltage to Ground : 1000V ( DC + peak AC ) or 600V RMS
Common Mode Rejection Ratio ( CMRR ):
60Hz : >10,000 : 1
100Hz: >1,000 : 1
1MHz: > 300 : 1
Noise :≦ 2 mV rms ( Into 50Ω load )
Input Impedance :
2MΩ, 2.3 PF between inputs and ground.
4MΩ, 1.2 PF between inputs.
Power :One internal 9V alkaline battery or external 6V-9V DC.

WARNING

1. Do not use DP-25 above 1000v ( DC + peak AC ) between ground and the input or 1,300V ( DC + peak AC ) between the input lead.
2. Do not operate DP-25 in wet or damp condition.
3. Do not operate DP-25 in an explosive atmosphere.
4. Do not immerse DP-25 in liquids.
5. Do not operated DP-25 without covers.
6. Please change the battery when the "LOW BATT " LED is lighted. At this time DP-25 can operate but not guaranteed the accuracy.
7. DP-25 can not operate if both POWER and LOW BATT LED are not light.

Pintek BP-256N IC clips
UL 1000V CAT III
Meets IEC-1010-1, UL-3111-1

Pintek BP-356 Banana plug to Banana plug cables
UL, 2KV, 18AWG
Max. Current : 10A
Length : 50 cm

Pintek BP-276 alligator clips 1KV
UL 1000V CAT III
Max. Current : 10A
Meet IEC-1010-1, UL-3111-1

Pintek BP-250 male BNC to male BNC cables
Wire Lenght :1.0M, male to mal
MAX. Input :3A / 500V RMS
Wire Property :5.0 mm, RG 58 A / u
Cu Wire :50Ω Coaxial BNC Cable
Insulated : Double Insulation
Safety Certifications : IEC-1010-1;UL-3111-1

Reviewed by 0 Customers